Looking for some knowledge.
I have been on about 10 different websites reading write-ups and taking notes. I am starting with a D16A6.
I will be swapping a D16Y8 head. I have read i need 9 A6/Z6 head studs, and 1 Y8 Head stud because it is shorter and goes in the back left corner close to Vtec solenoid.
As you can see, I ordered the OBD0-OBD1 ecu harness, Dizzy harnes, and the 4 wire 02 sensor.
That all should still be good!
My concern is that this kit, was purchased when I thought I had a Z6 head lined up, but seller backed out...
Can I use Z6 headgaskets on y8 mini-me?
I read that I should still be able to use the Z6 Timing belt since its same number of teeth as Y8.
And lastly, i have a Z6 Intake manifold/throttle body.
Will this Mini-me work with A6 Block, Y8 head, Z6 Intake???
Not sure where to start.